Hi I am at the stage of fixing the pins in my pin wheel escapement ( 92off x 1/32"dia) and I would be interested in your views of the prefered method of...
Hello all. I joined your group at the end of last year, but have been offline until now. (Holidaying on a palm fringed tropical island) I am a recent convert...
Hi All Following up on the earlier post The adjusting ttools are for adjusting escapements, the pointed end bends the lever and the crancked end with the...
Steve Painter Craft Coordinator Brisbane Chapter 104 Following my election to the above position I would like to give fellow members a brief rundown of my...
Greetings to all, I'm a new commer to this group, so I thought I would give an outline of where I'm at in relation to clocks & horology. I'm on a learning ...
Steve asked me post some of my clocks for you to see, I am surprised that you have not heard of me, however this is part of the reason I left Austalia. These...
I had a think about where to recomend and Smith & Smith in Sydney would be a good starting point I dont have contact details but I am certain there are some...
Absolutely inspiring. I also finally got to my most recently arrived NAWCC Bulletin with the article about David's Vienna style wall clock. If I understand...
Re the hyper links for Davids site If you copy the link then paste this into the address bar you will get into the page. For some reason I cant do this with...
Try this site to make manageable links.. http://makeashorterlink.com/index.php http://makeashorterlink.com/?Z597219D7 http://makeashorterlink.com/?L5D7269D7 ...
Hi guys, I'm a new member to the group and I've just uploaded some photos (Clocktyke) to share with you. There's two of my clocks and a few parts from my...
I think your subject for your first post Trevor should be New experienced member:>) Realy fine work here, good to see. Did you build the case for the regulator...
Hi Having used the quick links I have now veiwed all your sites, one point I picked up on was the reference to using the GD co-axial movement and seeking...
Hi Steve, unfortunately my talents do not run to fine woodworking. I have a friend who makes a living doing just that so I had him make the case for me. It is...
It looks like a copy of a Dent case from an August '83 Clocks magazine. It caught my eye, because my friend owns the one pictured in the Clocks magazine... ...
Hi Ralph, You may well be correct about the case. I followed the clock/case plans of John Wilding but I don't know where the case drawings originated. A note...
Hi Trevor, Now that you mention it, his regulator plus all the others I have been near have 2 locks. Nice job, Cheers, Ralph ... -- Cheers, Ralph My eBay Stuff...
Dear Trevor, Nice to see you as a new member. Steve Painter, Norm Heckenberg and I all live in Brisbane, Queensland, Australia and belong to the local NAWCC...
Hi Tony, I too am a member of our local NAWCC and I'm currently coaching a couple of guys in the making of a regulator. It's a slow process as they are making...
Steve, I am happy you are able to use the short links, they are very useful. On using someone's patented designs, no matter how large or small you make the...
I received in the mail a catalogue of the sale for the late walter Burkhardt who I believe was a member of chapter 122. On reading the items it became obvious...
If you are on the look out for miniture ball bearings visit wwww.cgb.com.au they carry a range of bearings from 1mm I/D x 3mm O/D x 1mm thick and they...
