You can set the sort order of messages. Just click on the link in the date column. Your preferences will be remembered, so you don't have to do it again when you return.
> I have been told a few times by learned authorities that schooner rigs
> don't point well :-)
Yes, shotover II didn't (doesn't) 'point' well.
When Adrian Rogers sailed it I observed that he 'pointed' a bit lower than the
boats around him. His VMG to windward however was startlingly better
than those
same boats that were 'pointing' higher. It's not where the bow is
pointing that
matters, it's where the boat goes, and how fast. A well set up schooner rig
will 'go' just as high and faster as demonstrated nearly 20 years ago by
Adrian.
PN
----------------------------------------------------------------
This message was sent using MyMail
Hi All, BacK after a while. See the list is somewhat quiet. Must be all building or sailing I guess. I see Farrier is finally going to make the 22 footer...
Sailing in my case. Tried a beam mounted rudder today. Steers the boat very well, but a few details still to sort. Max speed 12 knots in 10 knots of breeze...
ed to design a foil suitable for getting the ww hull up on the plane. I think it can be done but becomes pretyy mechanically complex as you have to have means...
... boat very well, but a few details still to sort. Max speed 12 knots in 10 knots of breeze so I am slowly getting the bugs out. Went past an International...
I have been told a few times by learned authorities that schooner rigs don't point well :-) Yesterday it was a Foundation 36 (well equipped quick keel boat...
... Yes, shotover II didn't (doesn't) 'point' well. When Adrian Rogers sailed it I observed that he 'pointed' a bit lower than the boats around him. His VMG to...
... hull. No foils required. ... After exploring how to stick a foil on, that is clearly the better option. Still, I had to do the mental exploration because...
If using polyprop honeycomb, the vertical strip as used by Farrierlooks pretty good, Yes, but glassing the bottom and topsides in one side full length on a...
Checked out prices and engineering details of polycore. 2.6MPa compressive strength and 0.5MPa sheer seems pretty good value when 2/3 the price of Kiri strip...
G'day, Spoke to Bob August at Polycore yesterday. He reckons vacuuming is no problem, resin into the core is minimal. I am not sure we (or anyone else) have...
I was looking at the shape and reckon it could be accommodated by three conic sections without the revesse sheer and five conic sections with. The top could...
The unknown question is how much will it compound so that flat shapes can be tortured into the required shapes and the effect of cutting darts to facilitate...
-I was wondering if the property of epoxy resin softening slightly if raised above its initial curing temperature could facilitate the torture. Have the...
G'day, I have copied this to Bob August who can answer these questions. I made up a trial piece of 19mm with 400 double bias on one side the other day. Bent...
No prices on Arripiado (they keep getting paid for big cats, spec proas go on the backburner) or Elementarry (quite possibly going to be the best finished...
Offline 
Send Email